Testing the Focusrite Scarlett 2i2 external sound device, with my Samsung Tab S Tablet

I have tested, whether this external USB recording tool, works with my Samsung Galaxy Tab S Tablet, using an ‘‘ OTG adapter. The results were resoundingly affirmative.

Scarlett 2i2 _1

In This Earlier Posting, I had tested the same USB Sound Card, with my Samsung Galaxy S6 Smart-Phone. At that time, an attempt also to use it with my Tab S tablet had failed. In order to get the to work with the Tab S, the following two conditions need to be fulfilled:

  1. The amount of current that the USB Slave Device may draw, needs to be reinforced, in principle, with a self-powered OTG adapter, or with a similar arrangement. The ‘‘ is Not a self-powered OTG adapter, and with it, the is bound to draw too much current, for the likes of the Tab S. It was after all meant as an audio workstation workhorse, and not as a replacement for a simple USB Microphone.
  2. The Master / Host Device, the Tab S, needs to have the correct drivers.

Condition (1) is something I was able to fulfill for now, in a roundabout way. I bought a ‘‘, with the part number ‘JUH340′. This is a self-powered hub by default, with its own power cord, and has Type A USB connectors up-stream and down-stream. Granted, it has a special up-stream cable, that connects to the hub with a special connector, just so that the user does not get this socket confused with the down-stream sockets. But then, the far side of that cable has a standard Type A USB jack.

This USB jack can be plugged, into the far side of the OTG adapter. Since the hub is self-powered, the current requirements of the are met by it, and not by the OTG adapter, and thus not by the micro-USB port on the Tab S, the latter of which now faces a minimum current load.

Continue reading Testing the Focusrite Scarlett 2i2 external sound device, with my Samsung Tab S Tablet

Testing the Focusrite Scarlett 2i2 external sound device, with my Samsung S6 Smart-Phone

I have tested, whether this external USB recording tool, works with my Samsung Galaxy S6 Smart-Phone, using an ‘‘ OTG adapter. The results were mixed. In An Earlier Posting, I had tested whether this external USB Sound Card, works under Linux. And the answer to that question was a resounding Yes.

Scarlett 2i2 _1

When we plug an OTG adapter into a smart-phone or tablet, this puts the mobile device into Master / Host Mode, that would otherwise normally work in Slave Mode. Thus, we can then plug in a USB storage device, and hopefully have that recognized, while by default, we can only plug our mobile device into a computer, and have the computer recognize this mobile device, as the storage device.

But it is also plausible to connect other external devices to our mobile device, when using an OTG adapter. All this happens because the OTG adapter itself contains an additional chip, that gives it the ability to act as a USB Host. Whether such external devices will work or not, generally depends on two factors:

  1. Whether the micro-USB port on the mobile device can output enough current, to supply the external / Slave device, and
  2. Whether the mobile device possesses the drivers needed, for the USB device in question. Under Linux, this last question is more likely to be answered in the affirmative.

The OTG adapter I was using, uses its micro-USB side as the only power-supply. This means that if the connected device draws a full 500mA of supply current, we are pushing the limit, that is generally set for USB 2.0  PC ports.

Continue reading Testing the Focusrite Scarlett 2i2 external sound device, with my Samsung S6 Smart-Phone